Filter
Top Products
15
ADJUSTMENT
The instructions below describe how each part of the weight system can be adjusted. Refer to the exercise
guide accompanying this manual to see how the weight system should be set up for each exercise. IMPOR-
TANT: When attaching the lat bar or nylon strap, make sure that the attachments are in the correct start-
ing position for the exercise to be performed. If there is any slack in the cables or chain as an exercise
is performed, the effectiveness of the exercise will be reduced.
54
53
53
52
58
19
Weight
Tube
Stops
ADDING WEIGHTS TO THE WEIGHT CARRIAGE
To add resistance to your workout, slide an equal
amount of weight (not included) onto each side of the
weight tube on the Weight Carriage (19). Make sure
that the weights are pushed against the stops. Note:
Due to the cables and pulleys, the actual amount
of resistance at each exercise station may vary
from the amount of weight used. Use the WEIGHT
RESISTANCE CHART on page 17 to find the actu-
al amount of resistance at each weight station.
ATTACHING THE LAT BAR OR NYLON STRAP TO
A PULLEY STATION
Attach the Lat Bar (54) to the Long Cable (58) with a
Cable Clip (53). For some exercises, the Chain (52)
should be attached between the Lat Bar and the Long
Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the Long Cable so
the Lat Bar is in the correct starting position for
the exercise to be performed.
The Nylon Strap (not shown) can be attached in the
same manner.
The accessories can be attached to the Short Cable
(not shown) in the same manner.
WARNING: Do not place more
than 125 pounds on the weight carriage.