Filter
Top Products
7
5. Press a 45mm Square Inner Cap (44) into the top
of one of the Press Arms (46). Press a 25mm
Round Inner Cap (49) into each end of the handle
on the Press Arm. Attach the Press Arm to one
side of the Press Frame (17) with two M8 x
63mm Bolts (22) and two M8 Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
6. Identify the the Left Arm (47) and Right Arm (48).
Note the position of the welded bracket on each
Arm. Arm identification is important for step 7.
Press a Butterfly Arm Bushing (60) into each Arm.
7. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle of the
Top Frame (55). Note: Be careful not to con-
fuse the Right Arm with the Left Arm (47);
refer to step 6 to identify the Right Arm. Be
sure that the upper end of the Right Arm is
behind the indicated bracket on the Top
Frame.
Tap two 25mm Retainers (63) and a 25mm Round
Cover Cap (62) onto the right axle of the Top
Frame (55). Be sure that the teeth on the
Retainers bend toward the Cover Cap, as
shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press two 45mm Square Inner Caps (44) into the
lower ends of the Left and Right Arms (47, 48).
Wet the lower end of each Arm with soapy water.
Slide a Large Foam Pad (45) onto the lower end of
each Arm.
46
3
22
Handle
17
44
49
5
48
60
47
Welded
Brackets
6
7
Bracket
Lubricate
Axle
45
47
55
48
45
44
63
62
63
55
62