Filter
Top Products
9
11. Slide an M10 Washer (6) onto the M10 x 155mm Bolt
(22). Lubricate the Bolt.
Place the Backrest (15) onto the Adjustment Tube
(29). Slide the M10 x 155mm Bolt (22) through the
right Backrest Tube (27) and then slide a 16mm x
18.5mm Spacer (8) onto the Bolt.
Line up the M10 x 155mm Bolt (22) with the hole in
the Bench Frame (5) and slide the Bolt through the
Frame until the tip is barely visible on the other side.
Place a 16mm x 18.5mm Spacer (8) between the
Bench Frame and the left Backrest Tube (27) and
slide the Bolt through both the Spacer and the
Backrest Tube. Secure the Bolt with an M10 Washer
(6) and an M10 Nylon Locknut (11). Do not over-
tighten the Nylon Locknut. You must be able to
freely pivot the Backrest. Tighten the four M6 x
38mm Screws (4) used in step 10.
11
6
22
8
15
29
27
6
5
11
10. Press a 1Ó Square Inner Cap (28) into each end of
the two Backrest Tubes (27).
Attach the Backrest Tubes (27) to the Backrest (15)
with four M6 x 38mm Screws (4) and four M6
Washers (30). Note: Do not tighten the four
Screws yet.
10
15
4
28
4
27
30
30
28
8. Press the Angle Cap (49) onto the indicated end of
the Weight Tube (39). Press a 1Ó Round Inner Cap
into the opposite end of the Weight Tube. Slide a
Weight Stop (53) onto the Weight Tube.
Lubricate the M10 x 68mm Bolt (34). Attach the Leg
Lever (18) to the indicated hole in the bracket on the
Front Leg (19) with the Bolt and an M10 Nylon
Locknut (11). Do not overtighten the Nylon
Locknut. You must be able to freely pivot the Leg
Lever.
8
19
18
53
12
39
11
49
Lubricate
34
9. Press a 1Ó Round Inner Cap (12) into each end of the
Adjustment Tube (29).
Insert the Adjustment Tube (29) into the indicated
holes in the Uprights (1) in the following manner:
First, slide the end with no locking clip partway
through the right Upright. Next, slide the end with the
locking clip into the left Upright as far as it will go.
Finally, rotate the Adjustment Tube until the locking
clip snaps into place around the Upright.
9
1
12
1
29
12
Locking
Clip
Lubricate