Filter
Top Products
10
15
15. Press a Carriage Bushing (2) onto each end of the
Weight Carriage (47).
Press a 1Ó Round Inner Cap (12) into each end of the
weight tube on the Weight Carriage (47).
Insert the M10 x 19mm Bolt (46) through the bracket
on the Weight Carriage (47) from the indicated direc-
tion.
2
46
2
12
47
12
13. Press a 3/4Ó Round Inner Cap (54) into each end of
the three Pad Tubes (38).
Slide a Foam Pad (10) onto one end of each Pad
Tube (38).
Slide the free end of each Pad Tube (38) into the indi-
cated holes in the Leg Lever (18) and the bracket on
the Front Leg (19). Secure the Pad Tubes by sliding
another Foam Pad (10) onto each of them.
13
54
38
54
10
54
10
54
10
19
38
18
54
38
10
54
14. Locate the Cable (45) and note that it has a closed
loop on one end and a ball on the other. Slide the
closed loop through the slot in the Lat Tower (9) from
the direction shown.
Place the Cable (45) in the groove of the Pulley (35)
and attach the Pulley inside the slot in the Lat Tower
(9) with the M10 x 62mm Bolt (48), two M10 Washers
(6), two Pulley Spacers (41) and an M10 Nylon
Locknut (11).
Press a 45mm x 45mm Square Inner Cap (24) into
the top of the Lat Tower (9).
14
41
6
9
11
35
6
41
24
45
48
12. Attach one end of the Seat (14) to the indicated hole
in the Bench Frame (5) with an M6 x 63mm Screw (7)
and an M6 Washer (30).
Attach the other end of the Seat (14) to the bracket
on the Bench Frame (5) with two M6 x 16mm Screws
(3).
12
14
5
3
7
30