Filter
Top Products
7
17
11
17
33
25
33
31
11
3. Note: The Left Stabilizer (25) has a tube that
allows you to store the Curl Pad and Lat Tower
(44 and 9, not shown). Depending on where you
plan to place the weight bench, it may be more
practical for you to have this storage tube on the
right side of the bench. If so, simply switch the
two Uprights (1) before attaching the Crossbar
(20).
Insert two M10 x 68mm Bolts (34) through the holes
in one of the Support Plates (16) and then through
the indicated holes in one Upright (1).
While a second person is holding the Upright (1),
slide the bracket on the Crossbar (20) over the two
M10 x 68mm Bolts (34). Secure the Crossbar with
two M10 Nylon Locknuts (11).
Attach the Crossbar (20) to the second Upright (1) in
the same manner.
16
34
1
1
3
2. Press a 2Ó Square Inner Cap (17) into the top end of
one Upright (1).
Press a 2Ó Square Inner Cap (17) into each end of
the Left Stabilizer (25).
Press a 38mm x 38mm Square Inner Cap (31) into
the top of the tube on the Left Stabilizer (25).
Insert three M10 x 62mm Carriage Bolts (33) through
the holes in the Left Stabilizer (25). Note: On one
side of the Stabilizer there is an indentation
around the holes. Insert the Bolts from this side.
Place the Stabilizer flat on the floor.
Place the Upright (1) over the three M10 x 62mm
Carriage Bolts (33) in the Left Stabilizer (25). Secure
the Upright with three M10 Nylon Locknuts (11). Do
not tighten the Nylon Locknuts yet.
2
1
17
11
11
20
11
11
25
34
16