Vision Fitness ST740 Home Gym User Manual


 
11
AC1
AC1
AG1
AG1
AG2
AG2
G10
G10
Stickers
1
STEP
NOTE: During assembly, it is recommended
to ensure that all bolts are in place and
partially threaded before completely
tightening any one bolt. During assembly
steps 1 thru 5, do not completely tighten
any bolts until completion of Step 5.
• Lay the side floor support (AC1) with the
pads face down. Place the center floor
support (AG1) against the side support,
lining up with holes in center of the side
floor support (make sure the colored stickers
are side by side on AC1 & AG1). Place
one flat washer (10.2x22x2) on each of
two bolts (M10x70) and slide through
holes, securing with one flat washers
(10.2x22x2) and one nylon nut (M10) on
each bolt.
• Place the swing arm support (AG2)
against the holes of the center floor
support. Attach with two bolts (M10x70),
four flat washers (10.2x22x2), and two
nylon nuts (M10).
• Attach the flat bracket (G10) to the
inside of the swing arm support (AG2)
using two bolts (M10x120), four flat
washers (10.2x22x2), and two nuts (M10).
ORANGE BAG