GB
OWNER’S MANUAL
•
T80 T85
3
training, we are certain this is the training equipment to
get you there. You’ll find information about using your
exercise equipment and what makes for efficient training
at Tunturi’s website at WWW.TUNTURI.COM.
ASSEMBLY
Before assembling the device, insure all parts are present:
PACKAGE 1/2
1.
Running base
PACKAGE 2/2
2.
Lower frame (Foldaway)
3. Handrails
4. Handlebar/console unit
5. Power cord
6. Assembly kit (contents are marked with an * in the
spare part list): keep the assembly tools, as you may need
them e.g. for adjusting the equipment
The directions left, right, front and back are defined as
seen from the exercising position. In case of problems
contact your Tunturi dealer. The package includes
a silicate bag for absorbing moisture during storage
and transportation. Two people are needed for the
installation. Assemble the equipment as follows:
T80 / T85 (FOLDAWAY)
Begin the assembly with package 2/2.
Do not remove the styrox foam pieces from under the
running base!
HANDRAILS
Fasten each handrail to the lower frame with four bolts
(A). Ensure that the base of the plastic cap at the lower
end of the handrails is lined up with the hole in the
lower frame. Be careful not to damage the wire coming
out of the left handrail. NOTE! Do not tighten these
bolts until the handlebar and console have been secured.
HANDLEBAR AND CONSOLE
Turn the sliders located at the sides of the handlebars
downward so that you can attach them with another
screw (B) through the lower hole of the handlebar.
NOTE! Attach the screws as loosely as possible. Do not
remove the screws on the sliders. Place the handlebar/
console unit on the handrails so that the sliders fit the
handrail grooves. Connect the wire coming out of the
left handlebar with the connector in the console and
push the connected wire inside the handlebar. Push
the handlebar/console unit onto the handrail ends and
tighten all the hex screws on the sliders. Fasten the
handrail bolts. Remove the protective film from the
display.
RUNNING BASE
Secure the attached lower frame and handlebar to the
running base according to the following instructions:
1. Remove the styrox foam piece from under the front
end of the running base as well as the boards at the sides
of the running base.
2. Turn forward the transportation wheels located at the
front end of the handlebar/console unit. Lift the front
end of the running base, and then push the attached
lower frame and handlebar under the front end of the
running base so that the front support of the lower
frame and the holes in the running base are lined up.
NOTE! Be careful not to damage the wire.
T80_T85_manual.indd 3T80_T85_manual.indd 3 28.2.2006 17:38:2928.2.2006 17:38:29