15
• If you want to stop monitoring data from your Bodylink
®
sensors,
hold the DISPLAY button down until the message HOLD TO
SHUT OFF RCVR is displayed on the watch display. Continue
holding the
DISPLAY button for a few more seconds; the watch
will beep indicating that the radio link between the watch and the
sensors has been shut down.
14
Messages
When using the Watch with the HR Sensor, the Watch may display
messages to communicate the status of the Sensor in conjunction
with the Watch. Messages include:
NO DATA FROM HRM The Watch is not receiving data
from the HR Sensor. Ensure the Sensor is not more than
3 feet (1 meter) away from the Watch, is operating, or has not
inadvertently locked on to someone else’s Sensor. The Watch
will attempt to establish a connection for one minute after this
message displays.
NOISY DATA FROM HRM The Watch is experiencing radio
interference. Try to move away from any potential sources of
interference (for example, televisions, monitors, or motorized
devices). The Watch will attempt to establish a connection for
30 seconds after this message displays.
Display formatting
In Chronograph Mode, you can press and release SET/FORMAT to
switch the data values displayed in the upper and middle display
lines. This allows you to display the value most important to you in
the larger, middle display.
TIP: If you are already viewing data from one sensor, for example,
the Heart Rate Sensor, and you wish to also view data from the
Speed + Distance Sensor, simply press and hold the DISPLAY
button until the watch emits a short beep and the antenna icon
begins flashing. The watch is now searching for a second
Bodylink
®
sensor. When it detects this second device, the antenna
icon will stop flashing and the display may change to a new
format that includes the new information. Press and release the
DISPLAY button (as detailed previously) to view various
combinations of two sensor’s data.