4544
Data Hiding: You can choose to show or hide blank data from the
HR Sensors. For instance, if you do not use the HR Sensor for your
workout and you choose to hide blank HR Sensor data, you will
not see any information related to heart rate since this data relies
on the use of the HR Sensor. Data hiding also includes an option
for S+D settings. See the next section for information on this
setting.
OPTIONAL GPS FUNCTIONALITY
You can add GPS functionality to your Watch by purchasing an
optional Speed + Distance Sensor (GPS-3D Sensor). The GPS-3D
Sensor tracks speed, pace, distance traveled, altitude, location, and
more, using GPS based technology. The Fitness Sensor User Guide
included with the GPS-3D Sensor provides detailed instructions
for setting up and using this sensor.
Sync Timer & Chrono: This feature allows you to set the interval
timer and the chronograph to start and stop simultaneously so you
can record chronograph data when you use the interval timer. The
completion of an interval in Interval Timer Mode will cause the
Watch to take a split in the chronograph. Use this feature if you
want a record of your performance for each interval in your
workout. Each interval corresponds to one lap or segment in Lap
Data Mode.
You must turn the Sync Timer & Chrono setting off if you want
the timer to switch to Chronograph Mode at the end of a
countdown in Basic Timer Mode.
Watch settings
Configure the following Watch settings:
Night-Mode® Feature: When enabled, the INDIGLO® night-light
turns on when you press any button. This feature disables itself
after eight hours.
Hourly Chime: When enabled, the Watch will chime at the top of
every hour.
Button Beep: When enabled, the Watch will emit a beep when you
press any button.
Mode Hiding: You can choose to show or disable the following
modes: Interval, Lap Data, Summary, Timer, or Alarm. For
example, if you disable Lap Data Mode it will not show up at all
until you enable it again from Configure Mode.