Filter
Top Products
3736
Timer Mode tips & tricks
➤ You can press MODE within Timer Mode to switch the display
to another mode without disrupting the operation
of the timer. The timer icon will appear indicating
timer operation.
➤ The timer will only switch to the Chronograph Mode if you reset
the chronograph to zero and Sync Timer & Chrono is turned off
(see “Hand-free settings” on page 43).
Basic Timer Mode example
Alarm Mode
You can use your Watch as an alarm clock for up to five separate
alarms. When you set an alarm, the alarm clock icon appears in
Time of Day Mode. The alarm can alert you at the same time every
day, or only weekdays, weekends, or even only one time (useful for
appointment reminders).
As part of your overall health plan, you decide to take a 30-minute
walk during your lunch hour two times a week. To help keep
track of time so you do not return late from your lunch hour, you
set the timer to 15 minutes and then set it to repeat one time.
After 15 minutes the Watch beeps telling you to begin walking
back to your office. Since you set the timer to repeat, the Watch
begins timing another 15 minute session helping you track how
much time you have to return to your office.
For Timer Mode, you can set the following values:
➤ Time (hours, minutes, seconds for up to 99 hours, 59 minutes,
and 59 seconds)
➤ End action (STOP, REPEAT, or CHRONO)
Operating the timer
1. Press START/SPLIT to start the timer countdown.
2. Pause the countdown by pressing
STOP/RESET. You may resume
the countdown by pressing START/SPLIT again, OR reset the timer
by pressing and holding STOP/RESET.
3. When the timer reaches zero, a brief alert sounds.
4. The timer will stop after the alert if set to
STOP.
OR
the timer will begin another countdown if set to
REPEAT and
continue until you press STOP/RESET.
The lower line of the display will show RPT and a number (for
example, RPT 2). RPT indicates the timer is repeating and the
number indicates how many times the timer has cycled
through the repeat countdown. You will also see the repeat
icon, indicating the timer is set to repeat.
OR
The timer will switch to Chronograph Mode if set to that mode. You
will see the switch mode icon, indicating the timer will
switch modes at the end of the countdown.