Filter
Top Products
TREADCLIMBER by STAR TRAC - OWNER’S MANUAL | Assembly & Setup
21
Assembly & Setup
Use the following procedures to unpack and assemble your TreadClimber
®
Unpacking & Parts List
Remove the top cover from the shipping carton. Remove all parts and shipping supports (except the base) from the
carton, and verify that the following parts are included in your shipment:
Parts List:
Console Frame
Neck Mast
Handrail Grommets
Upper Handrails (Left & Right)
Handrail Beauty Rings
Lower Handrails (Left & Right)
Rear Corner Shroud (Left & Right)
Hardware Pack
Rear Shroud
Neck Grommet
Take time now to enter your TreadClimber serial number in the space below (serial number is located along the base of the
frame in the front). If parts are missing, or if you have any operational questions, please call Star Trac’s Service department
at (800) 503-1221. Have your serial number ready.
Serial No._____________________________________________
NOTE: If you are missing any of the parts listed above, inspect the packing material and the box for items that may have
been overlooked. If parts are missing, or if you have any product questions, please call Star Trac’s Service Department at
(800) 503-1221, please have your TreadClimber serial number ready.
CAUTION: Damage to the TreadClimber during assembly is not covered as part of the limited Star Trac warranty.
Note: This manual covers installation of the LED display. If you ordered a PVS kit, please refer to the assembly
and operating instructions included with that product for proper setup and operation.
Tools Required
Your TreadClimber can be assembled using the following tools:
Metric Hex Key Wrenches
Metric Open-End Wrenches
Metric Ratchet Socket Wrench
30mm Socket for Raising Rear Wheels
SetTorque Wrench
Phillips Head Screwdriver