SET UP INSTRUCTIONS
10
FUNCTION INSPECTION:
Visually inspect the EMR ELLIPTICAL to verify that assembly is as shown in the above illustration. Check
the function of the
EMR ELLIPTICAL. Stand on the foot pedals and place your hands at a comfortable
position on the handlebars. Slowly move your highest foot forward and follow the natural path of the machine.
Turn the crank slowly through one complete revolution to verify that the drive train functions properly. Use
the "
/ " buttons on the COMPUTER(33) to select a program and verify that the Magnetic System
provides different tensions. Refer to the COMPUTER INSTRUCTIONS on pages 12 to 16.
Place the
EMR ELLIPTICAL in the area where it will be used. The max. operation dimensions of EMR
ELLIPTICAL is approximately 58 1/4" long x 25 5/8" wide x 61 3/8" tall. (These dimensions may vary up to
one inch.) An area 4 feet wide x 7 feet long is required for safe operation of the
EMR ELLIPTICAL. Make
sure that adequate space is available for access to and passage around the
EMR ELLIPTICAL.
LEVELING:
MOVING:
Adjust the
LEVELING CAPS(51) on the REAR STABILIZER(2) so that the elliptical sets
on the floor without rocking.
The
EMR ELLIPTICAL has a pair of MOVING WHEELS(49) built into the FRONT
STABILIZER(3) at the front. Grasp the center section of the HANDLEBARS(6, 7) and tip
the
EMR ELLIPTICAL forward to move.
GRASP HERE TO MOVE
GRASP HERE TO MOVE