Filter
Top Products
XG400 Elliptical
6
1. Feed the computer cable (95) up through the console mast tube (pulse grip posts at the top)
with the end of the twist tie that is attached to it.
2. Place the console mast tube onto the mating plate of the main frame; Be careful not to pinch
the Computer cable between the console mast and the main frame plates during assembly.
3. Secure the console mast in place with the four stainless steel bolts (42) and split washers (50).
Make sure the bolts are securely tightened using the 8mm Allen wrench (108).
4. Attach the console (78) to the bracket with four Phillips Head Screws (112) using the Phillips
Head Screw Driver (107).
5. Attach the hand brake lever (90) to the handlebars as follows:
CONSOLE MAST
1
#42. M10 x 20mm
Stainless Steel Bolt
(4 pcs)
#50. M10
Split Washer
(4 pcs)
HARDWARE
Remove the screw that is threaded into the nut on the backside of the hand brake with the
Phillips head screw driver (107)
Place the hand brake bracket around the front of the right handlebar vertical tube, then
insert the bolt through the back of the bracket and thread back into the nut. Tighten with the
Phillips head screw driver (107)
#112. M5 x 12mm
Phillips Head Screw
(4 pcs)