Filter
Top Products
XG400 Elliptical
5
ASSEMBLY TOOLS
1. Using a razor knife (Box Cutter), cut the banding straps that wrap
around the carton. Reach under the bottom edge of the carton and pull
it away from the cardboard underneath, separating the staples that join
the two together. Lift the box over the unit and unpack.
2. Carefully remove all parts from carton and inspect for any damage or
missing parts. If damaged parts are found, or parts are missing, contact
your dealer immediately.
3. Locate the hardware package. The hardware is separated into four
steps. Remove the tools rst. Remove the hardware for each step as
needed to avoid confusion. The numbers in the instructions that are
in parenthesis (#) are the item number from the assembly drawing for
reference.
PRE-ASSEMBLY
XG400 ASSEMBLY INSTRUCTIONS
#107. Phillips Head
Screwdriver
#108. 8mm Allen
Wrench
#109. 17mm
Wrench
#110. 5mm Allen
Wrench
#111. 13/14mm
Wrench
#116. 6mm Allen
Wrench