Filter
Top Products
XG400 Elliptical
19
There are two customizable User programs that allow you to build and save your own
workout. The two programs, User 1 and User 2, operate exactly the same way so there
is no reason to describe them separately. You can build your own custom program by
following the instructions below or you can save any other preset program you complete
as a custom program. Both programs allow you to further personalize it by adding your
name.
CUSTOM USER DEFINED PROGRAMS
1. Press the User 1 or User 2 key. The Message Center will show a welcome mes-
sage. If you had previously saved a program the message will contain your name.
Then press the Enter key to begin programming.
2. When you press Enter, the Message Center will show “Name - A”, if there is no
name saved. If the name “David” had been previously saved the Message Center
will show “Name - David” and the D will be blinking. If there is a name saved you
can change it or you may press the Stop key to keep the name and continue to the
next step. If you want to enter a name use the Up and/or the Down key to change
the rst letter then press Enter to save the rst letter and continue to the next
letter. When you have nished entering the name press the Stop key to save the
name and continue to the next step.
3. The Message Center will ask you to enter your Age. You may enter your age,
using the Level Up and Down keys, then press the Enter key to accept the new
value and proceed on to the next screen.
4. You are now asked to enter your Weight. You may adjust the weight value using
the Up and Down keys or the numeric key pad, then press Enter to continue.
5. Next is Time. You may adjust the time and press Enter to continue.
6. Now you are asked to adjust the Max Resistance Level of the program, press
Enter when resistance has been selected.
7. Now the rst column will be blinking and you are asked to adjust the resistance
level for the rst segment(SEGMENT > 1) of the workout by using the Level Up
key. When you nish adjusting the rst segment, or if you don’t want to change,
then press Enter to continue to the next segment.
8. The next segment will show the same workload resistance level as the previously
adjusted segment. Repeat the same process as the last segment then press enter.
Continue this process until all twenty segments have been set.
9. The Message Center will then tell you to press Enter to save the program. After
saving the program the Message Center says “New program saved” then will give
you the option to Start or modify the program. Pressing Stop will exit to the start
up screen.