Filter
Top Products
IMPORTANT!
• Pay attention to traffic and road
conditions at all times. Your first
obligation is to be attentive and
to ride safely.
• Keep your computer in good shape
and use it safely.
• Do not expose it to direct sunlight
except when you are riding.
• Do not disassemble it.
• Make sure the magnet and
the transmitter are well aligned.
Check them regularly.
• Keep the computer and all of its
components tightly attached, and
check them regularly. If any of the
components come loose, it could
become tangled in your spokes
and cause an accident.
21
INSTALLING THE BATTERY
Your SpeedZone Pro Computer comes
with the battery installed at the factory.
Should you need to replace the battery,
push the computer backward to re m o v e
it from the handlebar mount. Before
removing the battery make a note of
your odometer reading and wheel
c i rc u m f e rence settings so that you can
re-enter them when you re s t a rt the
c o m p u t e r. Tu rn the computer over so
the display is facing downward. Use a
coin to unthread the battery cap fro m
the computer. Install the battery (model
CR2302) with the positive pole (+)
facing upward. Carefully thread the
b a t t e ry cap back onto the case with
a coin. (See Figure 18)
If the LCD display is blank or shows
incomplete digits, turn the computer
over and press the "AC" button on the
bottom of the case with the tip of a pen
or a paper clip. This will clear all the
data and re - s t a rt the computer. Reinstall
the computer by pushing it forw a rd into
the mount until it snaps into place.
20
TROUBLESHOOTING
• Display is blank:
Change the battery or press the AC
button on the bottom of the case
• Display shows partial digits:
Press the AC button on the bottom
of the case.
• Speed/distance not recording:
Check sensor/magnet alignment.
Make sure that the sensor is no more
than 1/16" (2mm) from the magnet.
• Entire screen is dark:
Did you leave the bike parked in the
hot direct sun when it was parked?
If so, move the bike to the shade.
The data will be OK.
• Computer moves on handlebar:
Tighten mount or add sizing straps
to improve fit on handlebar.
FIGURE 18: BATTERY INSTALLATION
01_SDZN_PRO_USA_1-24.qxd 1/24/01 12:09 PM Page 20