Filter
Top Products
2. Setting the Programmable
Odometer
This mode is useful if you have
replaced the battery and would like to
retain the mileage you have already
ridden. To access the programmable
odometer mode, first advance the
"MODE" button until (ODO) appears
on the left-hand side of the screen.
Hold down the "FUNCTION" button
and ‘tap’ the "MODE" button once.
The Km/h indicator will flash. If the
Km/h setting is correct press the
"FUNCTION" button once and a five-
digit number will appear. You are now
in the programmable odometer mode.
To enter a mileage into the odometer,
press the "MODE" button until the
flashing digit is correct.
(Note: The "MODE" button may be
held to scroll to the correct digit.) Press
the "FUNCTION" button to select the
next digit to the right. Repeat this
process until all five digits are entered
as your existing mileage.
3. Wheel Circumference Selection
To set the circ u m f e rence for the type
of tires you are using, you can use
S p e c i a l i z e d ’s "Easy Calibration Mode"
or measure your actual tire circ u m f e r-
ence by the rollout method. Two diff e r-
ent tire diameters may be entered by
using the computer’s “Second Wheel
O p t i o n . ”
7
PROGRAMMING
Programming the functions of your
SpeedZone Pro requires it to be placed
in various "modes" (i.e. odometer
mode, distance mode). The computer
can be cycled through these modes by
pressing the "MODE" button located
on the right-hand side of the housing.
Once a specific mode has been
entered, its values can be reset or
adjusted by pressing either the
"FUNCTION" button located on the left
hand side of the housing or by using
a combination of the "MODE" and
"FUNCTION" buttons.
1. Miles or Kilometers selection
Your SpeedZone Pro will record speed
and distance in either miles (M/h) or
kilometers (Km/h). To enter your selec-
tion of miles or kilometers, push the
"MODE" button until ODO (odometer)
appears on the left side of the display
(This is called the odometer mode).
Hold down the "FUNCTION" (left side)
button and ‘tap’ the "MODE" button
once. The Km/h, m/h indicator will
begin blinking. You may now alternate
between miles and kilometers by press-
ing the "MODE" button. When the cor-
rect choice is flashing, select it by
pressing the "FUNCTION" button. You
will now enter the "Programmable
Odometer" mode. If the odometer set-
ting is correct push the "FUNCTION"
button five times to exit odometer
mode. (Otherwise, see "Setting the
programmable odometer" below).
6
01_SDZN_PRO_USA_1-24.qxd 1/24/01 12:09 PM Page 6