Filter
Top Products
Note: Altitude will be displayed in feet
when speed is measured in miles per
hour and meters when speed is meas-
ured in kilometers per hour.
10. Altitude Gained
The altitude gained function on your
Speedzone Pro calculates your total
elevation climbed. Descended altitude
is not counted.
COMPUTER FUNCTIONS
Speedometer
Speed is always indicated on the top
line of the screen. The speed is shown
continuously up to 99.9 M/h (99.9
Km/h) with a resolution of 0.1 M/h
(0.1 Km/h)
Average Speed (AVS)
The average speed is displayed on the
lower line of the screen when AVS is
shown on the left. The average speed
is based upon whether the ATM or the
TM mode has been selected, the reso-
lution of the average speed is shown in
0.1M/h or Km/h increments.
(See figure 13)
+/- Average Speed Indicator
An up or down arrow displayed in
the upper right side of the screen
15
7. Temperature
Your Speedzone Pro is equipped with
a therm o m e t e r. To enter temperature
gauge mode, press the “MODE” button
until “TMP” appears on the left-hand
side of the screen. To alternate between
°F and °C press the “FUNCTION” button.
8. Altimiter
Your Speedzone Pro contains an
ex t remely accurate altimeter that is
capable of re c o rding changes in alti-
tude in increments as small as three feet
(one meter). This altimeter calculates
altitude by precisely measuring baro-
metric pre s s u re. Due to normal changes
in barometric pre s s u re, you may need
to recalibrate your Speedzone Pro on
a daily basis. You should be able to
find the altitude where you live on a
topographical map or by contacting
a nearby airport.
9. Altimeter Calibration
To calibrate your altimeter press the
“MODE” button until “ALT” appears on
the left-hand side of the screen. Then
p ress the “FUNCTION” button for thre e
seconds. The first altitude digit will
begin flashing. Press the “MODE”
Button until the desired number
appears. Each push of the button will
change the altitude one-foot (or meter
if you selected metric units). Press the
“FUNCTION” button once to set this
number and advance to the next.
Repeat this process until you have
e n t e red the desired altitude. Press the
“FUNCTION” button to exit pro g r a m-
ming mode.
14
FIGURE 13: AVERAGE SPEED SCREEN
01_SDZN_PRO_USA_1-24.qxd 1/24/01 12:09 PM Page 14