Filter
Top Products
36
MOTION CONTROL OPERATION
MOTION CONTROL:
Walking belt speed can be increased, decreased or stopped using the Motion
Control sensors on the handlebars. To do this follow the instructions below:
1. Press the MOTION CONTROL button on the console to switch the
motion control function on and off:
• When the LED light is ON the MOTION CONTROL is active.
• When the LED light is OFF the MOTION CONTROL is off.
2. After switching on the MOTION CONTROL wave your right hand
approximately 6 inches above the motion sensor on the right handle bar
to increase the speed. The sensor will sound one short BEEP per scan
and speed up by 0.1 MPH per BEEP. Holding your right hand
approximately 6 inches above the right sensor constantly results in the
sensor sounding one long BEEP per second and speeding up rapidly.
2. Use right sensor to speed up.
3. Wave you left hand approximately 6 inches above the motion sensor on
the left handle bar to decrease the speed. The sensor will sound one
short BEEP per scan and decrease speed by 0.1 MPH. Holding your
left hand approximately 6 inches above the left sensor constantly results
in the sensor sounding one long BEEP per second and decreasing
speed by rapidly.
3. Use left sensor to slow down.
4. Wave both hands approximately 6 inches above both motion sensors at
the same time. The sensor will sound two short BEEP sounds then stop
the belt.
• Always switch off the motion control function by pressing the
MOTION CONTROL button on the console before turning off the
power to the treadmill.
4. Use both sensors to stop belt.