Filter
Top Products
19
CE2.0 Crosstrainer
www.smoothfitness.co.uk
Training in WATT mode:
The preset value 120 is flashing on screen in WATT setting mode, select UP/DOWN/ENTER to set target
value from 10 to 350. Pressing
Training in BODY FAT mode:
You may test and have the BODY FAT advice when the computer is in STOP mode. Please follow the
steps as below:
Step I – Make sure the personal data has been input properly
Step II – Press BODY FAT button and hold on handgrip to start body fat testing.
Step III – The symbol “-------“ will appear on the display during the testing period of 8 seconds. After 8
seconds you will see the BADY FAT advice in percentage (*1) and BMI (*2) and the fat advice in
a different symbol. It is possible that another indicator appears if the following situation occurs
a. “ E1” – When you see this indication, it means you did not put your thumb properly on the
sensor. Please try again.
b. “E2” – When you see this indication, it means the BADY FAT advice is exceeded the
available area which is fixed in the program.
After BODY FAT testing, press the BODY FAT button. The computer will continue from the previous data before
testing. The BODY FAT advice figure and BMI will disappear. The computer will allow other users to test BODY
FAT when in the STOP mode. The user can press RESET button for 4 seconds to select new user identification
and input new personal data. Then follow each step as above to do the new testing.