Filter
Top Products
ASSEMBLY
Assembly requires two persons. Set the treadmHUin a cUeared area and remove aUUpacking materiaUs, Do not
dispose of the packing materiaUsuntil assembUyis compUeted, Note: The underside of the treadmiUUwaUking beUtis
coated with high-pedormance Uubricant, During shipping, a smaUUamount of Uubricant may be transferred to the
top of the waUking beUtor the shipping carton, This is a normaUcondition and does not affect treadmiUUpedor-
mance, Ufthere is Uubricant on top of the waUking beUt,simpUywipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner,
E
AssembJy requires the included allen wrenches _ and your own philtips screwdriver
and wire cutters __ ._.
Use the drawings below to identify the assembly hardware, The number in parentheses below each drawing is
the key number of the part, from the PART LIST on pages 26 and 27, The number after the parentheses shows
the quantity needed for assembly, Note: If a part is not in the parts bag, check to see if it is preattached to one of
the parts to be assembled, If a part is missing, cult toil-free 1-888-533-1333.
Extension Leg Bolt (96)-4
1/4" Washer
(39)-4
Internal Star
Washer (77)-4
1" Tek Screw (80)-2
Upright Bolt (78)-4
Latch Screw (79)-2
©
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully raise the
Uprights (97) to the position shown, Insert one of the
Extension Legs (92) into the right Upright, (Note: It may
be helpful to tip the Uprights forward as you insert the
Extension Leg.) Make sure that the Warning Decal (91)
is in the indicated location,
Insert the other Extension Leg (not shown) in the same
way.
92
97