Filter
Top Products
13.Keepthepower cord and the surge suppres- 23. inspect and properly tighten all parts of the
sor away from heated surfaces, treadmill regularly.
14. Never move the walking belt while the power
is turned off. Do not operate the treadmill if
the power cord or plug is damaged, or if the
treadmill is not working properly. (See BE-
FORE YOU BEGIN on page 4 if the treadmill
is not working properly.}
15. Never start the treadmill while you are stand-
ing on the walking belt. Always hold the
handrails while using the treadmi&
t& The treadmill is capabJe of high speeds.
Adjust the speed in small increments to
avoid sudden jumps in speed.
17. Never leave the treadmill unattended while it
is running. Always remove the key, unplug
the power cord and move the reset/off circuit
breaker to the off position when the treadmill
is not in use. (See the drawing on page 4 for
24. Never insert any object into any opening.
25.DANGER: AlwoysunpUugthepower
cord immediately after use, before cleaning the
treadmilJ, and before performing the mainte-
nance and adjustment procedures described in
this manual Never remove the motor hood uric
less instructed to do so by an authorized ser-
vice representative. Servicing other than the
procedures in this manual shouJd be performed
by an authorized service representative onJy.
26. This treadmill is intended for in-home use
only. Do not use this treadmill in a commero
cial, rental or institutional setting.
27. The decals shown below have been placed
on your treadmill, if a decal is missing, or if it
is not legible, please cal! toll-free f-888=533-
the location of the circuit breaker.)
18. Do not attempt to raise, lower, or move the
treadmHJ until it is properly assembled. (See
ASSEMBLY on page 5, and HOW TO FOLD
AND MOVE THE TREADMILL on page 21.)
You must be abJe to safely tift 45 pounds (20
kg) to raise, lower, or move the treadmill
19. When foJding or moving the treadmill, make
sure that the storage latch is fully closed.
20. When using iFIT.com programs, an elec-
tronic "chirping" sound will alert you when
the speed and/or incline of the treadmill is
about to change. Always listen for the
"chirp" and be prepared, in some instances,
the speed and/or incline may change before
the personal trainer describes the change.
21. When using iFIT.com programs, you can man-
ually override the speed and incline settings
by pressing the speed and incline buttons.
However, when the next "chirp" is heard, the
speed and/or incline will change to the next
1333 and order a free replacement decal
AppJy the decal in the location shown. Note:
The decals are not shown at actual size.
KEEPHANDSANDFEETAWAY
FROMTHISAREAWHILETHE
TREADMILLIS IN OPERATIO!',
Protect yourse fand
others from rEskof serous
r'july. Read the usels
manua and :
":ardng_am° 5top
",_;::?%L.l,:,_,_n
e_enl _ =g sn
:at:V¢ll';_r, r:
=t_p_vour_ t,
r rJ*_ ,rp ]m_l,.
•, i_,,<v_c0r
settings of the CD or video program.
22. Remove iFIT.com CDs and videos from your
CD player and VCR and disconnect your _P3 SAVE THESE NSTRUCTIO NS
player when you are not using them.
WARNING: e orebeginningth soranyexerciseprogram,consultyourphysic,an.
is especially important for persons over the age of 35 or persons with pre-existing health problems.
Read all instructions before using. Sears assumes no responsibility for personal injury or property
damage sustained by or through the use of this product.