Filter
Top Products
With the heUpof a second person, carefully raise the
Upright Base (97) as shown, Carefully pivot the Hood
(113) off,
Locate the Reed Switch (22) and the Magnet (19) on
the left side of the Pulley (18), Turn the Pulley until the
Magnet is aligned with the Reed Switch, Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8". if necessary, loosen the Screw
(23) and move the Reed Switch slightly, Retighten the
Screw, Reattach the Hood, and run the treadmill for a
few minutes to check for a correct speed reading,
PROBLEM: The walking belt slows when walked on
1/8"--+-_ _._-. / 18
[ 22 N
Top L
View
SOLUTION: a, Use only a single-outlet surge suppressor that meets all of the specifications described on page 8,
b,
if the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged, Remove the key and UNPLUG THE
POWER CORD, Using the allen wrench, turn both
rear roller adjustment bolts counterclockwise, 1/4 of a
turn, When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 2 to
3 inches off the walking platform, Be careful to keep
the walking belt centered, Hug in the power cord, in-
sert the key, and run the treadmill for a few minutes,
Repeat until the walking belt is properly tightened,
Rear Roller Adjustment Bolts
c, if the walking belt still slows when walked on, please call toll-free 1-800°4°MY-HOME _ (1o800o
469-4663),
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a,
If the walking belt is off-center, first remove the key
and UNPLUG THE POWER CORD, If the walking
belt has shifted to the left, use the allen wrench to
turn the left rear roller bolt clockwise 1/2 of a turn; if
the waJking belt has shifted to the right, turn the
bolt counterclockwise 1/2 of a turn, Be careful not to
overtighten the walking belt, Plug in the power cord,
insert the key, and run the treadmill for a few minutes,
Repeat until the walking belt is centered,
b,
If the waJking belt stips when waJked on, first re-
move the key and UNPLUG THE POWER CORD,
Using the allen wrench, turn both rear roller bolts
clockwise, 1/4 of a turn, When the walking belt is cor-
rectly tightened, you should be able to lift each side of
the walking belt 2 to 3 inches off the walking platform,
Be careful to keep the walking belt centered, Hug in
the power cord, insert the key, and carefully walk on
the treadmill for a few minutes, Repeat until the walk°
ing belt is properly tightened,
23