Filter
Top Products
9
7. Identify the Right Handrail Endcap (91), which
does not have a cutout in the bottom, and slide it
onto the lower end of the Right Handrail (11).
Make sure that the screw hole in the Right
Handrail Endcap is at the bottom. Next, hold the
Right Handrail near the Right Upright (36), and
insert the Upright Wire (28) into the hole in the
bottom of the Right Handrail and out of the indi-
cated hole in the top. Then, remove the tie from
the Upright Wire.
Set the Right Handrail (11) on the Right Upright
(36) while sliding the lower end of the Right
Handrail onto the bracket on the Right Upright.
Hand tighten two Handrail Bolts (20) with two
Handrail Star Washers (19) into the Right
Handrail and the Right Upright. Next, slide the
Right Handrail Endcap (91) against the Right
Upright, and tighten an Endcap Screw (95) into
the Right Handrail Endcap. Then, tighten the two
Handrail Bolts. Make sure that the Upright
Wire (28) is not pinched.
Attach the Left Handrail (18) and the Left
Handrail Endcap (90) to the Left Upright (31) as
described above.
36
31
95
95
91
90
Cutout
28
20
19
18
19
20
11
7
6. Pull the indicated wire until the Upright Wire (28)
is extending from the upper end of the Right
U
pright (36). Then, disconnect and discard the
wire.
Remove the elastic bands from the Left and
Right Base Leg Covers (101, 102) and press
them onto the Base (48) as shown.
36
102
48
101
6
28
Wire