Filter
Top Products
10
9. Pivot the cylinder end of the Gas Spring (112)
down to the position shown. Remove the Spring
Clip (105) from the end of the Gas Spring.
Next, align the cylinder end of the Gas Spring
(112) with the bracket in the center of the Base
(48). Press the end of the Gas Spring onto the
ball on the bracket. Note: It may be necessary to
pivot the Frame (not shown) forward or backward
slightly to align the end of the Gas Spring with
the ball.
See drawing 9a. Insert the Spring Clip (105) into
the two indicated small holes in the Gas Spring
(112). Then, rotate the Spring Clip until it clips
onto the Gas Spring.
With the help of a second person, lower the
Frame (not shown) to the floor.
105
112
112
48
48
Holes
105
9a
Bracket
Bracket
9
8. Have a second person raise and hold the tread-
mill Frame (74).
Identify the Gas Spring (112). Note that the Gas
S
pring has a cylinder end and a rod end. See the
two small inset drawings. Locate the Spring Clip
(105) in the rod end of the Gas Spring. Using
your fingernail or the end of a screwdriver, press
on the end of the Spring Clip to loosen it, rotate
the Spring Clip, and then pull the Spring Clip out
of the Gas Spring. Be careful to avoid losing the
Spring Clip.
Note: Extra Spring Clips are in-
cluded.
Next, hold the rod end of the Gas Spring (112)
near the bracket in the center of the Frame (74).
Press the end of the Gas Spring as far as possi-
ble onto the ball on the bracket.
See drawing 8a. Insert the Spring Clip (105) into
the two indicated small holes in the rod end of
the Gas Spring (112). Then, rotate the Spring
Clip until it clips onto the Gas Spring.
112
105
112
74
74
Bracket
Cylinder
R
od
Bracket
8a
8
1
05
105
Holes
105