Filter
Top Products
23
Follow the on-line instructions to start the
p
rogram.
W
hen you start the program, an on-screen count-
down will begin.
Return to the treadmill and stand on the foot
rails. Find the clip attached to the key and slide
the clip onto the waistband of your clothes.
When the on-screen countdown ends, the pro-
gram will begin and the walking belt will begin to
move. Hold the handrails, step onto the walking
belt, and begin walking. During the program, an
electronic “chirping” sound will alert you when the
speed and/or incline of the treadmill is about to
change.
CAUTION: Always listen for the
“chirp” and be prepared for speed and/or in-
cline changes.
If the speed or incline settings are too high or too
low, you can manually override the settings at any
time by pressing the Speed or Incline buttons on
the console.
However, when the next “chirp” is
heard, the speed and/or incline will change to
the next settings of the program.
To stop the walking belt at any time, press the
Stop button on the console. The time will begin to
flash in the display. To restart the program, press
the Start button or the Speed increase button.
After a moment, the walking belt will begin to
move at 2 Km/H.
When the next “chirp” is
heard, the speed and incline will change to the
next settings of the program
.
When the program ends, the walking belt will stop.
Note: To use another program, press the Stop
button and go back to step 5.
Note: If the speed and/or incline of the tread-
mill does not change when a “chirp” is heard,
make sure that the indicator above the iFIT
button is lit and that the time is not flashing in
the display. In addition, make sure that the
audio cable is properly connected.
Follow your progress with the display.
See step 5 on page 17.
When you are finished exercising, remove the
key from the console.
See step 8 on page 17.
THE INFORMATION MODE/DEMO MODE
T
he console features an information mode that keeps
track of treadmill usage information and allows you to
s
elect a unit of measurement for the console.
To select the information mode, insert the key into the
console while holding down the Stop button, and then
release the Stop button. When the information mode is
selected, the following information will be shown:
An “E” (for English) or an “M”
(for metric) will appear in the
lower right corner of the dis-
play. Press the Speed in-
crease button to change the
unit of measurement, if de-
sired.
IMPORTANT: If a “d” appears in the display, the
console is in the “demo” mode. This mode is intended
to be used only when a treadmill is displayed in a store.
When the console is in the demo mode, the power cord
can be plugged in, the key can be removed from the
console, and the display will remain lit, although the
buttons will not operate.
If a “d” appears when the in-
formation mode is selected, press the Speed de-
crease button so the “d” disappears.
The upper left corner of the
display will show the total
number of hours that the
treadmill has been used.
The lower left corner of the
display will show the total
number of kilometers (or
miles) that the walking belt
has moved.
To exit the information mode, remove the key from the
console.
9
8
7
6