Filter
Top Products
1. Make sure that the power cord is unplugged.
I
dentify the Right Upright (36), which has a
square hole in the location shown. Slide the
R
ight Base Leg Cover (102) onto the Right
Upright.
Orient the Right Upright (36) and the Base (48)
as shown. Attach the Right Upright to the Base
with two Upright Bolts (40) and two Upright Star
Washers (39);
do not tighten the Upright Bolts
yet.
48
40
39
36
1
02
1
2. Orient the Left Upright (31) as shown, and slide
the Left Base Leg Cover (101) onto the Left
Upright.
Attach the Left Upright (31) to the Base (48) with
two Upright Bolts (40) and two Upright Star
Washers (39); do not tighten the Upright Bolts
yet.
Raise the Uprights (31, 36).
48
31
101
39
39
36
2
Square
Hole
40
3.
Place an elastic band around the Right Base Leg
Cover (102) and the bracket on the Right Upright
(36) as shown. Place another elastic band
around the Left Base Leg Cover (not shown) and
the bracket on the Left Upright (not shown).
Position the Base (48) near the front of the tread-
mill as shown.
Locate the wire in the Right Upright (36). See the
inset drawing. Tie the wire
securely to the con-
nector on the Upright Wire (28). Then, insert the
connector into the square hole in the Right
Upright.
48
36
Bracket
Band
102
3
Wire
28
36
7
28
Wire