Filter
Top Products
18
H
OW TO USE A PRESET PROGRAM
I
nsert the key into the console.
S
ee HOW TO TURN ON THE POWER on page
16.
S
elect a preset program.
To select one of the ten
preset programs, press
the Program Select but-
ton repeatedly until one
of the programs num-
bered “P–1” through
“P–10” appears in the display. When a preset pro-
gram is selected, the maximum incline setting of
the program and the maximum speed setting of
the program will flash in the display for a few sec-
onds. The display will also show how long the pro
-
gram will last. A profile of the
speed settings of the
program will scroll across the matrix in the upper
right corner of the display.
Press the Start button or the Speed increase
button to start the program.
A moment after the button is pressed, the tread-
mill will automatically adjust to the first speed and
incline settings of the program. Hold the handrails
and begin walking.
Each program is divided into several one-minute
periods. One speed setting and one incline setting
are programmed for each period. Note: The same
speed setting and/or incline setting may be pro-
grammed for two or more consecutive periods.
The speed setting for
the first period will be
shown in the flashing
Current Period column
of the matrix in the dis-
play. (The incline set-
tings are not shown in the matrix.) The speed set-
tings for the next four periods will be shown in the
columns to the right.
When only three seconds remain in the first period
of the program, both the Current Period column
and the column to the right will flash and a series
of tones will sound. If the speed and/or incline of
the treadmill is about to change, the speed setting
and/or the incline setting will flash in the display to
alert you.
When the first period is completed,
all speed set-
tings will move one column to the left
. The speed
s
etting for the second period will then be shown in
the flashing Current Period column and the tread-
m
ill will automatically adjust to the speed and in-
cline settings for the second period. Note: If all five
of the indicators in the Current Period column are
lit,
the speed settings may move downward
so that
only the highest indicators appear in the matrix.
The program will continue in this way until the
speed setting for the last period is shown in the
Current Period column and the last period ends.
The walking belt will then slow to a stop.
If the speed or incline setting for the current period
is too high or too low, you can manually override
the setting by pressing the Speed or Incline but-
tons. Every few times a Speed button is pressed,
an additional indicator will appear or disappear in
the Current Period column; if any of the columns
to the right of the Current Period column have the
same number of lit indicators as the Current
Period column, an additional indicator may appear
or disappear in those columns as well.
Important:
When the current period of the program ends,
the treadmill will automatically adjust to the
speed and incline settings for the next period.
To stop the program temporarily, press the Stop
button. The time will begin to flash in the display.
To restart the program, press the Start button or
the Speed increase button. The walking belt will
begin to move at 2 Km/H. When the next period of
the program begins, the treadmill will automatically
adjust to the speed and incline settings for the
next period. To end the program, press the Stop
button, remove the key, and then reinsert the key.
Follow your progress with the display.
See step 5 on page 17.
Measure your heart rate if desired.
See step 6 on page 17.
Turn on the fan if desired.
See step 7 on page 17.
When the program is completed, remove the
key from the console.
See step 8 on page 17.
7
6
5
4
3
2
1
Current Period