Filter
Top Products
8
7. Slide the Right Crank Arm (38) onto the four indicated
welded bolts; make sure that the Right Crank Arm is
in the indicated cutout in the Left Pedal Disc (8).
Next, finger tighten four M8 Jamnuts (101) onto the
welded bolts. Then, fully tighten one of the Jamnuts,
and then tighten the Jamnut farthest from the first
Jamnut. Then, tighten the remaining two Jamnuts.
Attach a Hub Cover (48) to the Right Crank Arm (38)
with four Cover Screws (82). Then, tighten an
Adjustment Knob (45) onto the right
Adjustment Pin (17).
7
38
Cutout
82
48
101
Welded
Bolts
8
101
45
17
6. While another person holds the Console (5) near the
Upright (2), connect the wire harness on the Console
to the Upper Wire Harness (86). Insert the excess
wire harness down into the Upright. Next, attach the
Console to the Upright with four M4 x 16mm Screws
(66).
Be careful to avoid pinching the wire har-
nesses.
5
86
66
66
2
Wire
Harness
6
5. The Console (5) requires four “D” batteries (not includ-
e
d); alkaline batteries are recommended.
I
MPOR-
TANT: If the ellipical exerciser has been exposed to
c
old temperatures, allow it to warm to room tem-
perature before inserting batteries into the
Console. If you do not do this, the console dis-
plays or other electronic components may become
d
amaged.
P
ress the tab on the battery cover and
r
emove the battery cover. Insert four batteries into the
Console as shown.
Make sure that the batteries are
oriented as shown by the markings on the battery
cover.
Reattach the battery door.
5
5
Batteries
Batteries
Battery
Cover
Avoid pinching the
wire harnesses
during this step