Filter
Top Products
7
4
2
46
67
15
83
83
95
86
76
72
Hexagonal
Holes
4. While another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (86) to
the Extension Wire Harness (95).
Next, insert the Upright (2) into the Mast (15);
make
sure that the Upright is oriented as shown. Attach
the Upright with two M8 x 70mm Button Bolts (67), two
M8 Split Washers (83), and two M8 Nylon Locknuts
(46). Be careful to avoid pinching the Wire
Harnesses (86, 95) during this step. Do not tighten
the Button Bolts yet.
Attach the Water Bottle Holder (72) to the Upright (2)
with two M4 x 22mm Screws (76).
Avoid pinching the
wire harnesses
during this step
3. Slide an M10 Split Washer (94) onto each of the two
M
10 x 83mm Button Screws (63). Insert the Button
Screws into the Front Stabilizer (3). Next, slide the
M
ast (15) onto the Button Screws and against the
Front Stabilizer. Make sure that the Mast is oriented
as shown.
W
hile another person holds the Mast (15) and the
F
ront Stabilizer (3) near the Frame (1), connect the
Extension Wire Harness (95) to the Lower Wire
Harness (87). Insert the connectors on the Wire
Harnesses into the Mast.
While the other person lifts the front of the Frame (1),
carefully pull the upper end of the Extension Wire
Harness (95) to remove any slack. While holding
the upper end of the Extension Wire Harness,
attach the Mast (15) and the Front Stabilizer (3) to the
Frame with the two M10 x 83mm Button Screws (63).
Do not tighten the Button Screws yet.
Be careful to avoid pinching the Wire Harnesses
(87, 95) during this step.
94
3
1
63
3
15
95
87
Pull
Avoid pinching the
w
ire harnesses
during this step