Filter
Top Products
1. Remove the key from the console and unplug
the power cord.
Remove the Screw (3) and the Access Door
(76) from the back of the Console Base (85).
2. Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Base
(85).
Hold the receiver so the small cylinder
is oriented as shown and is facing the
Console Base.
Attach the receiver to the plastic
posts on the Access Door (76) with the two in-
cluded small screws.
3. Make sure that no wires are pinched.
Reattach the Access Door (76) with the Screw
(3). Discard the other wires included with the re-
ceiver.
9
If you purchase the optional chest pulse sensor (see page 18), follow the steps below to install the receiver
included with the chest pulse sensor
.
A
85
Small
Cylinder
3
76
Wire
10. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used
to adjust the walking belt (see pages 22 and 23).
9. Hand tighten four additional Screws (3) into the
Handrail (20) and the console assembly. Then,
tighten all nine Screws used in step 8 and
this step; do not overtighten the Screws.
Console Assembly
3
20
9
3
Small Screws
8. Set the console assembly on the Handrail (20).
Be careful to avoid pinching any of the
w
ires. Make sure that the ground wire (see
step 6) and the wire harness from the con-
s
ole assembly (see step 7) are in the indi-
cated channel.
Hand tighten five Screws (3) into the Handrail
(20) and the console assembly. Start all five
Screws, but do not tighten them yet. Do not
put Screws into the two indicated holes.
Console Assembly
3
3
No Screws
3
20
8
Channel