Filter
Top Products
7. While the second person continues to hold the
console assembly, locate the wire harness un-
derneath the console assembly.
Connect the wire harness from the console as-
sembly to the
Wire Harness (77)
.
See the inset
drawing. The connectors should slide to-
gether easily and snap into place.
If the con-
nectors do not slide together easily and snap
into place, turn one connector and then try
again.
IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Then, insert the connectors
downward into the Handrail (20).
8
77
Console
Assembly
77
20
6. While a second person holds the console as-
sembly near the Handrail (20), attach the
ground wire to the indicated hole in the Handrail
with a Ground Screw (33).
20
Hole
Ground
Wire
Console
Assembly
33
6
7
5. Lower the Frame (not shown) (see HOW TO
LOWER THE TREADMILL FOR USE on page
2
0).
Have a second person hold the Handrail (20)
near the Uprights (84). Insert the Wire Harness
(77) into the hole in the bottom of the Handrail
and out of the top as shown.
Next, set the Handrail (20) on the Uprights (84).
Do not let the Wire Harness (77) fall into the
right Upright.
Attach the Handrail (20) with four Handrail Bolts
(64) and four Star Washers (8); start all four
Handrail Bolts and then firmly tighten them.
84
20
8
8
77
64
84
64
5
Wire Harness