Filter
Top Products
9
6. See the left inset drawing in step 5. Identify
the outer side of the remaining Frame Spacer
(11).
Hold the Frame Spacer (11) between the Left
Upright (53) and the Lift Frame (23), with the
outer side of the Frame Spacer facing the
L
eft Upright. Attach the Left Upright to the Lift
Frame with an M10 x 60mm Patch Bolt (1), an
M10 Flat Washer (14), and an M10 Star Washer
(9); do not fully tighten the Patch Bolt yet.
6
53
14
11
9
23
1
1
14
9
53
11
23
7. Set the Console (91) face down on a soft sur-
face to avoid scratching the Console. Hold the
Right Handrail (33), which has a large hole in
one side, near the Console.
Next, insert the console wire and the tie into the
large hole in the side of the Right Handrail (33).
Using needlenose pliers, pull the console wire
out of the hole near the bracket on the Right
Handrail.
Then, set the Right Handrail (33) on the Console
(91). Make sure that no wires are pinched.
Start an M5 x 16mm Screw (85) with an M5 Star
Washer (7) into the Right Handrail, and then
start two M4.2 x 19mm Screws (10) into the
Right Handrail. Tighten the M5 x 16mm Screw
and then tighten the two M4.2 x 19mm
Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the
Console (91) in the same way. Note: There are
no wires on the left side.
7
Console
Wire
Large
Hole
33
Bracket
85
7
10
91
Tie
Top View