Filter
Top Products
1111
10. Attach the Latch Housing (48) and the Latch
Housing Spacer (109) to the Left Upright (53)
w
ith two #10 x 1" Tek Screws (112); start both
Tek Screws before tightening either of them.
M
ake sure that the large hole in the Latch
Housing is on the indicated side.
Locate the Latch Pin Assembly (24). Remove
t
he knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are
two collars, place one on each side of the
spring.) Insert the pin into the Latch Housing
(48). Then, tighten the knob onto the pin.
112
Pin
Spring
Collar
Knob
48
109
53
Large Hole
1
0
24
11. With the help of a second person, carefully
lower the Uprights (not shown) to the floor.
Attach the ground wire on the Wire Harness (39)
to the indicated hole in the Base (52) with an M4
x 10mm Ground Screw (84).
52
39
Ground Wire
11
84
Hole