Filter
Top Products
16. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
in a secure place. One hex key is used to adjust the walking belt (see pages 23 and 24). To protect the floor
or carpet, place a mat under the treadmill.
13
14. Have a second person lift and hold the Frame
(51) until step 15 is completed.
P
lace the cylinder end of the Gas Spring (129)
near the bracket on the Base (52).
See the two small inset drawings. Using your
fingernail or the end of a screwdriver, press on
the end of the Gas Spring Clip (128) to loosen it
from the Gas Spring (129). Next, rotate the Gas
Spring Clip and pull it out of the Gas Spring. Be
careful to avoid losing the Gas Spring Clip.
See the lower drawing. Press the cylinder end
of the Gas Spring (129) onto the ball on the
bracket. Next, insert the end of the Gas Spring
Clip (128) through two of the small holes in the
end of the Gas Spring. Then, rotate the Gas
Spring Clip until it clips onto the Gas Spring.
129
128
129
128
14
52
51
Bracket
Cylinder
Bracket
128
128
15. Raise the Gas Spring (129) to a vertical posi-
tion. Remove the Gas Spring Clip (128) from the
raised end of the Gas Spring as described in
step 14. If necessary, rotate the Gas Spring to
align the end of the Gas Spring with the ball on
the bracket on the Frame (51).
Then, press the end of the Gas Spring (129)
onto the ball. Note: It may be necessary to
move the Frame (51) forward or backward as
you press the Gas Spring onto the ball.
See the lower drawing. Insert the Gas Spring
Clip (128) into the two indicated small holes in
the end of the Gas Spring (129). Then, rotate
the Gas Spring Clip until it clips onto the Gas
Spring. Note: Extra Gas Spring Clips are in-
cluded.
Lower the Frame (51) to the floor.
128
129
Holes
128
129
15
51
Bracket
Holes