Filter
Top Products
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the walking belt is coated
with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the
walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there
is lubricant on top of the walking belt, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys, your own phillips screwdriver , and your
own rubber mallet .
For help identifying the assembly hardware, see the drawings below.
The number in parentheses below each
drawing is the key number of the part, from the PART LIST on pages 30 and 31. The number following the paren-
theses is the quantity needed for assembly.
Note: If a part is not in the parts bag, check to see if it has been
pre-assembled. To avoid damaging plastic parts, do not use power tools for assembly.
3/4” Tek Screw (58)–8
1
Silver Ground
Screw (33)–1
1/4” Star Washer
(
H
W
Latch Screw
(XXX)–2
Handrail Bolt (20)–4
Extension Leg Bolt (64)–4
Star Washer (8)–8
Screw (3)–11
Handrail Bolt (50)–4
Handrail Bolt/Extension Leg Bolt (64)–8
1” Tek Screw
(22)–4
6
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side as shown. Partially
fold the Frame (58) so the treadmill is more sta-
ble. Do not fully fold the treadmill until it is
completely assembled.
Insert an Extension Leg (89) into the base of the
Upright (84) as shown. Note: Be careful not to
pinch the Upright Wire Harness (77) in the
base of the Upright. To fully insert the
Extension Leg, it may be necessary to tap on it
with a mallet. Next, insert two Extension Leg
Bolts (64) with Star Washers (8) into the bottom
of the Extension Leg, and firmly tighten the
Extension Leg Bolts.
8
1
58
89
64
77