Filter
Top Products
H
OW TO USE A TRAINER PROGRAM
I
nsert the key into the console.
See HOW TO TURN ON THE POWER on page
13.
Select a trainer program.
To select
one of the
trainer pro-
grams,
press the
Trainer
Programs
button re
-
peatedly
until one of the program indicators (“P1” through
“P10”) appears in the display. When a trainer pro-
gram is selected, the program time will appear in
the display, the maximum incline setting of the
program and the maximum speed setting of the
program will flash in the display for a few seconds,
and a profile of the speed settings of the program
will scroll across the display.
Press the Start button or the Speed increase
button to start the program.
A moment after you press the button, the treadmill
will automatically adjust to the first speed and in-
cline settings of the program. Hold the handrails
and begin walking.
Each program is divided into 30, 50, or 60 one-
minute segments. One speed setting and one in-
cline setting are programmed for each segment.
Note: The same speed setting and/or incline setting
may be programmed for two or more consecutive
segments.
The speed
setting for
the first seg-
ment will be
shown in
the flashing
Current
Segment column of the display. (The incline set
-
tings are not shown in the upper part of the dis-
play.) The speed settings for the next several seg-
ments will be shown in the columns to the right.
When only three seconds remain in the first seg-
m
ent of the program, both the Current Segment
column and the column to the right will flash and a
series of tones will sound. If the speed and/or in-
cline of the treadmill is about to change, the speed
setting and/or the incline setting will flash in the
display to alert you.
When the first segment is completed,
all speed
settings will move one column to the left
. The
speed setting for the second segment will then be
shown in the flashing Current Segment column
and the treadmill will automatically adjust to the
speed and incline settings for the second seg-
ment. Note: If all of the indicators in the Current
Segment column are lit,
the speed settings may
move downward
so that only the highest indicators
appear in the display.
The program will continue in this way until the
speed setting for the last segment is shown in the
Current Segment column and the last segment
ends. The walking belt will then slow to a stop.
If the speed or incline setting for the current seg-
ment is too high or too low, you can manually
override the setting by pressing the Speed or
Incline buttons. Every few times a Speed button is
pressed, an additional indicator will appear or dis-
appear in the Current Segment column; if any of
the columns to the right of the Current Segment
column have the same number of lit indicators as
the Current Segment column, an additional indica-
tor may appear or disappear in those columns as
well.
Important: When the current segment
ends, the treadmill will automatically adjust to
the speed and incline settings for the next seg
-
ment.
To stop the program at any time, press the Stop
button. The time will begin to
flash in the display.
To restart the program, press the Start
button or
the Speed increase button. The walking belt will
begin to move at 2 km/h. When the next segment
of the program begins, the treadmill will automati-
cally adjust to the speed and incline settings for the
next segment.
3
2
1
Current Segment
15