Filter
Top Products
8
If you purchase the optional chest pulse sensor (see
page 17), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated Screw (2) and the Access Door
(76) from the back side of the Console Base (85).
2. Connect the wire on the receiver (A) to the indicated
wire extending from the Console Base (85). Hold the re-
ceiver so the small cylinder is oriented as shown
and is facing the Console Back. Attach the receiver to
the plastic posts on the Access Door (76) with the two
included small screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (76) with the Screw (2). Discard the other
wires included with the receiver.
A
85
Small
Cylinder
2
76
Wire
Small
Screws
5. Attach the Latch Housing (73) to the left Upright
(
84) with two 3/4" Screws (2);
s
tart both
Screws and then tighten them. Note: Make
sure that the large hole in the Latch Housing
is on the indicated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin.
(Note: If there are two collars, place one on
each side of the spring.) Next, insert the pin into
the Latch Housing (73). Then, tighten the knob
onto the pin.
2
Pin
Spring
Collar
Knob
73
6. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the large hex key is
used to adjust the walking belt (see page 20).
8
4
Large Hole
5