Filter
Top Products
14
HOW TO USE A CALORIE WORKOUT
1
. Insert the key into the console.
S
ee HOW TO TURN ON THE POWER on page
11.
2. Enter your weight.
See step 2 on page 11. Note: Always enter your
weight before using a calorie workout; the
speed and incline settings of the workout will
depend on the weight setting that you enter.
3. Select a calorie workout.
To select
one of the
four calorie
workouts,
press the left
Select button
repeatedly.
When a calo-
rie workout is
selected, the display will show the calorie goal (the
approximate number of calories to be burned dur-
ing the workout) and the number of minutes that
the workout will last. In addition, the maximum in-
cline setting of the workout and the maximum
speed setting of the workout will flash in the dis-
play. A few seconds after a calorie workout is se-
lected, a profile of the speed settings of the work-
out will scroll across the display.
4. Press the Start button to start the workout.
A moment after the button is pressed, the treadmill
will automatically adjust to the first speed and in-
cline settings of the workout.
Hold the handrails
and begin walking.
Each workout is divided into 30, 35, 40, or 45 one-
minute
segments.
One speed setting and one in
-
cline setting are programmed for each segment.
Note: The same speed setting and/or incline setting
may be programmed for two or more consecutive
segments.
During the
workout, the
p
rofile will
show your
p
rogress. The
flashing seg-
ment of the
profile represents the current segment of the work-
out. The height of the flashing segment indicates
the speed setting for the current segment. At the
end of each segment, a series of tones will sound
and the next segment of the profile will begin to
flash. If a different speed and/or incline setting is
programmed for the next segment, the speed or in-
cline setting will flash in the display to alert you.
The workout will continue in this way until the last
segment of the profile flashes in the display and
the last segment ends. The walking belt will then
slow to a stop.
If the speed or incline setting for the current
segment is too high or too low, you can manually
override the setting by pressing the Speed or
Incline buttons.
Important: When the current seg-
ment of the workout ends, the treadmill will au-
tomatically adjust to the speed and incline set-
tings for the next segment.
To stop the workout at any time, press the Stop
button. To restart the workout, press the Start but-
ton or the Speed increase button. The walking belt
will begin to move at 1 mph. When the next seg-
ment of the workout begins, the treadmill will auto-
matically adjust to the speed and incline settings for
that segment.
Important: The calorie goal is an estimate of
the number of calories that you will burn during
the workout. The actual number of calories that
you burn will depend on your weight. In addi-
tion, if you manually change the speed or in
-
cline of treadmill during the workout, the num
-
ber of calories you burn will be affected.
Current Segment