Filter
Top Products
13
7. Measure your heart rate if desired.
N
ote: If you use the handgrip pulse sensor and
the optional chest pulse sensor at the same
t
ime, the console will not display your heart
rate accurately.
Before using
the handgrip
pulse sensor,
remove the
sheets of clear
plastic from
the metal con-
tacts. In addi-
tion, make
sure that your hands are clean.
To measure your heart rate,
stand on the foot
rails
and hold the metal contacts on the handrail—
avoid moving your hands. When your pulse is de-
tected, a heart-shaped indicator will flash in the
right side of the display each time your heart beats,
one or two dashes will appear, and then your heart
rate will be shown. For the most accurate heart
rate reading, continue to hold the contacts for
about 15 seconds.
8. Turn on the fan if desired.
T
he fan features low and high speed settings.
Press the fan button repeatedly to select a fan
s
peed or to turn off the fan. Note: If the fan is on
when the walking belt is stopped, the fan will turn
off automatically after a few minutes.
9. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
or you may damage the treadmill when you fold it
to the storage position.
Next, remove the key from
the console and put it in a secure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord.
IMPORTANT: If you do not
do this, the treadmill’s electrical components
may wear prematurely.
Contacts