Filter
Top Products
12
If one of the numbered buttons is pressed, the walk-
ing belt will gradually change speed until it reaches
t
he selected speed setting.
T
o stop the walking belt, press the Stop button.
The time will begin to flash in the display. To restart
the walking belt, press the Start button, the Speed
increase button, or one of the numbered buttons.
5. Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline increase and de-
crease buttons. Each
time a button is pressed,
the incline will change by
0.5%. Note: After the buttons are pressed, it may
take a moment for the treadmill to reach the se-
lected incline setting.
6. Follow your progress with the display.
Note: The display features six background col-
ors. To select a color, press the Display Color
button repeatedly. To adjust the contrast of the
display, see THE INFORMATION MODE on page
17.
When the
manual
mode is se-
lected, the
display will
show a track
that represents 1/4 mile. As you walk or run, indica-
tors will appear in succession around the track until
t
he entire track appears. The track will then disap-
pear and the indicators will again begin to appear in
s
uccession.
The left side of the display
will show the elapsed time,
the distance that you have
walked or run, and the in-
cline level of the treadmill.
Note: When a workout is
selected, the display will show the time remaining
in the workout instead of the elapsed time.
The right side of the dis-
play will show the ap-
proximate number of
calories you have burned
while walking or running,
the speed of the walking
belt, and your pace in minutes per mile. The right
side of the display will also show your heart rate
when you use the handgrip pulse sensor or the op-
tional chest pulse sensor.
Note: The console can display speed and distance
in either miles or kilometers. To find out which unit
of measurement is selected or to change the unit
of measurement, see THE INFORMATION MODE
on page 17.
Note: For simplicity, all instructions
in this section refer to miles.
To reset the display, press the Stop button, remove
the key, and then reinsert the key.
Track