Filter
Top Products
S3.19 Assembly and Maintenance Guide
page 21
1 2 3 4 5 6
8. Install Leg Extension Cable
A. Remove the hex head bolt from the Gusset which is
welded to the Base Frame. Place the end of the
Leg Extension Cable 130210 on the bolt as shown.
Secure the cable end by reinserting the fasteners:
one 2¼-inch hex head bolt
one locknut
Wrench tighten.
B. Disassemble the 3½-inch pulley at the base of the
Multiplier Arm. Wrap the cable around the pulley
and secure it using
one 2¼-inch zinc hex head bolt
1 cable guard
two zinc flat washers
one zinc locknut
Wrench tighten.
C. Feed the cable through the Main Base and beneath
the 3½-inch pulley located inside the Gusset.
D. Attach the threaded end of the cable to a Single
Floating Pulley. Continue turning the screw three to
four full turns to secure it inside the floating pulley
housing. Rest the Single Floating Pulley on the
floor.
Step 8. Install Leg Extension Cable
A
B
C
D
1 - 2¼" bolt
1 - locknut
1 - 2¼"zinc bolt
1 - cable guard
2 - zinc washers
1 - zinc locknut
1 - 2" bolt
2 - washers
1 - locknut
Multiplier Arm
Single Floating
Pulley
Gusset
Leg Extension
Cable 130210