Filter
Top Products
S3.19 Assembly and Maintenance Guide
page 16
1 2 3 4 5 6
5. Assemble Press Arm
Important: Obtain adult assistance to attach the Press
Arm Assembly.
A. Attach the Press Arm Assembly, with the label
facing out, to the Top Beam using
one ¾-inch x 5¼-inch threaded shaft
two 1-inch zinc buttonhead bolts
two zinc flat washers
Wrench tighten.
Note: Make sure the Press Arm rotates freely. If
resistance exists, loosen the fasteners a ¹⁄₄ turn.
Step 5. Assemble Press Arm
A
1 - ¾" threaded shaft
2 - 1" zinc buttonhead bolts
2 - zinc washers
Top Beam
Press Arm
Assembly
Label on Press Arm Assembly