Filter
Top Products
S3.19 Assembly and Maintenance Guide
page 20
1 2 3 4 5 6
E. Feed the cable over the lower 3½-inch pulley
located in the Press Arm assembly. Attach the
pulley to the Press Arm assembly using
one 2-inch zinc hex head bolt
two zinc flat washers
one zinc locknut
F. Feed the cable over the upper 3½-inch pulley
located in the Main Upright. Attach the pulley to the
Main Upright using
one 4-inch hex head bolt
two 1¼-inch shoulder spacers
one locknut
G. Pull the slack out of the Lat Pulley Cable so the ball
end of the cable rests against the Lat Bar Holder.
H. Feed the threaded end of the cable between the
two 3½-inch pulleys inside the Double Floating
Pulley.
J. Let the Double Floating Pulley hang as you
continue to feed the cable through the hole in the
Upper Frame Crosspiece and over the two 3½-inch
pulleys attached to the Top Beam assembly.
Reattach the pulleys to the assembly using
two 2-inch hex head bolts
four flat washers
two locknuts
K. Feed the cable down through the hole in the Upper
Frame Crosspiece and attach the threaded end of
the cable into the Selector Stem. Continue turning
the screw three to four full turns to secure the
threads inside the Selector Stem.
L. Wrench tighten all pulley fasteners.
Important: Do not tighten the Double Floating
Pulley fasteners or the jam nut on the threaded end
of the cable, at this time.
Step 7. Install Lat Pulley Cable, continued
H
K
J
E
F
G
Pull slack and place the
excess cable on the floor
while you assemble the
Double Floating Pulley.
2 - 2" bolts
4 - washers
2 - locknuts
1 - 2" zinc bolt
2 - zinc washers
1 - zinc locknut
Lat Bar Holder
1 - 4" bolt
2 - shoulder spacers
1 - locknut