Filter
Top Products
LCD Screen Assembly
1. Attach pivot assembly to back of LCD monitor using upper two mounting holes as
shown in figure 1. Leave out the lower two mounting screws until after all wiring is
installed onto back of monitor.
2. Install monitor assembly onto upper stand tube using (3) M4 X 10mm socket head
cap screws as shown in Figure 2
3. Install power connector from harness that was installed into stand assembly
earlier, to input on back of monitor labeled “DC12V” as shown in figure 3.
4. Plug Screen Controller cable from stand harness to telephone type RJ45 plug on
back of monitor. (Figure 4)
Figure 1 Figure2
Figure 3 Figure 4
8