Cable Management System
The Optional Cable Management System is used to cover the antenna cable and
power cords that run between the individual stands. It consists of a metal bracket
that connects to the bottom of the monitor stand and a plastic two-channel
extrusion that can be cut to length with common hand tools.
5 foot Cable Management extrusion.
Cable Management Bottom view of bracket
Mounting bracket mounted with four screws
Installation Instructions
Step 1
After monitors are mounted to stands and the proper spacing between equipment
has been determined, measure distance between stands and cut Cable
Management extrusion to length.
Step 2
Remove Allen Head screw from plastic bottom cover of stand. Place mounting
bracket over same hole and re-install the Allen Head screw.
Step 3
Place Cable Management extrusion into end of bracket and install 4 self tapping
screws, two on each side of bracket.
Repeat on opposite side of extrusion.
12