Filter
Top Products
Mounting Screen Controller
CNTE-4 CNTE-16
1. Remove backing from neoprene mounting pad and place either vertically
or horizontally around equipment handrail as appropriate as shown below.
2. Insert two nylon wire ties (provided) through the bottom holes in the
mounting bracket on the rear of the Screen Controller.
3. Attach wire ties as tightly as possible around the horizontal or vertical bar so the
controller can’t be rotated. This is very important to keep moisture out of the
controller and to keep from damaging the electronics inside unit.
ΝΟΤΕ: Do not place controller where it would interfere with the cardio unit
controls or display panel. The Screen Controller mounting bracket may
be removed with pliers and mounted with Super Lock Velcro to any flat
surface.
10