Filter
Top Products
Stand Assembly
Step 2
Step 1
Determine width of stand feet in relation to the
cardio equipment. Use a 7/16 wrench to secure
2 hex screws per leg.
Insert lower vertical tube over center stub
and hand install one 3/16 Allen head screw a
few turns into vertical tube. Do not tighten
at this time. (Clearance needed for Wires)
Step 4
Step 3
Insert upper curved tube into lower tube. Do
not install bolts until step 5 is performed,
then adjust upper tube to desired height and
install two Allen screws as shown above.
Insert plastic base cover over lower vertical
tube. Do not fasten down at this time.
Step 6
Step 5
Mount power supply with 2 wire ties to the
base assembly. Plug power supply connector
Insert cable assemblies through upper tube
opening and bring out lower tube hole as shown.
into cable previously installed down vertical
tube.
3