Filter
Top Products
page 20
QUICK START™: Provides two different options to bypass the setup prompts:
• If you press QUICK START at the Precor banner, a message scrolls across the display “Belt
Starting 3, 2, 1,...” The running belt begins moving at 1 mph and the Manual course profile
appears in the display. When you press Hold to Reset or stop your workout, the accumulated
workout statistics are not stored because the program is not associated with a user I.D.
• If you press ENTER while the Precor banner scrolls across the display, the user I.D. that was
last entered into the treadmill’s memory appears. Pressing QUICK START, at this point,
accesses the last program that you used. The display prompts you to press the SPEED ▲
key and begin your workout. At the end of your workout, the accumulated statistics are
stored with your user I.D.
If no information is stored in the treadmill’s memory for the user I.D. displayed on the electronic
console, pressing QUICK START causes the Manual program to appear on the display. For more
information, refer to
Using the QUICK START Feature
.
Changing the Display to U.S. Standard or Metric
The M9.25i treadmill can display speed in either miles per hour (mph) or kilometers per hour (kph)
and distance in miles or kilometers. When the M9.25i is shipped from the factory, it is set to
display to U.S. Standard units of measure (mph and miles). You can easily change this setting by
taking the following steps:
Note: The M9.25i treadmill will retain your selection even when it is turned OFF and unplugged.
You can change your selection at any time by repeating the following steps.
1. Insert the magnetic safety key into the electronic console.
2. Turn ON “ I ” the treadmill using the power switch located at the front of the hood.
3. At the Precor banner, press the STOP key, followed immediately by the QUICK START key,
then the SPEED ▼ key, and lastly the SPEED▲ key. (The numbers 5, 6, 7 appear sequen-
tially on the display as you press the associated key.) The prompt, “PRESS ▲ FOR MPH OR
▼ FOR KPH” appears on the display.
Important: If the QUICK START key is not pressed within 1 second after pressing the STOP
key, the display returns to the Precor banner. You will need to begin again.
4. Any ▼ or ▲ key lets you alternate between the prompts. Press one of the▼ or ▲ keys to
make your selection.
5. Press ENTER to return to the Precor banner.
The changes have been retained in the treadmill’s memory. To begin a workout, refer to
Working
Out on the M9.25i Low Impact Treadmill
. If you prefer, you can turn OFF the treadmill once you
have completed steps 1 through 5.
CAUTION: Hold onto the handrails when you
press the QUICK START key. The running belt
begins moving at 1 mph after a warning
message scrolls, “Belt Starting 3, 2, 1, ...”