Filter
Top Products
C O M M E R C I A L P R O D U C T S D I V I S I O N
Short and long handrail option packages exist for the C964i and C962i tread-
mills. When you receive the handrail option package, check its contents with the
corresponding list below:
Short Handrail Option Long Handrail Option
One short handrail One long handrail
Two end clamps Two end clamps
One center clamp One center clamp
Three large bolts Three large bolts
One locknut One locknut
One rubber washer One rubber washer
One 1/4" hex key One 1/4" hex key
Note: To assemble the handrail(s), you will need the original 3/16" hex key that
came with your unit and a utility blade or Xacto
TM
knife to pierce the label along
the siderail at the mounting bolt locations.
ASSEMBLY INSTRUCTIONS
The assembly of the short or long handrail is the same, except for the location
of the end mount along the siderails. To properly install the handrail(s) on your
unit, take the following steps:
CAUTION: Turn OFF the unit and unplug it from the power source before
installing the handrails.
1. Using the 3/16" hex key remove the handrail end covers (the “covers” are
large black washers). Set the covers aside and discard the bolts because
they are being replaced by the bolts in the hardware kit.
Important: Install a handrail on one side of the treadmill before proceeding
to the other side. Attach the front portion of the handrail first. This helps you
determine where to cut the siderail label to attach the lower end of the
handrail.
C964i and C962i Handrail Options
C O M M E R C I A L P R O D U C T S D I V I S I O N